A change to a bridge drive can alter the forces acting on the bridge. Wear in a bearing can affect how a lock gate moves. HIGTEC brings civil and mechanical engineering together to help asset managers, contractors and engineering teams design, assess and renovate infrastructure. We identify the loads, trace how they pass between mechanical and structural components, and assess what a proposed design change means for the asset as a whole.

At the start of a project, we review the engineering question, the available asset records and the functional requirements. Depending on the scope, we support concept development, preliminary design and detailed engineering. We can also review or verify an existing design. We document the governing assumptions and identify any gaps in the available information. This gives you a basis for comparing design options in terms of constructability, maintenance access and compatibility with the existing structure.
We assess bridge decks, girders, bearings and connections, with particular attention to how they transfer loads. For movable bridges, we also assess the operating machinery, shaft bearings and the forces transmitted from the drive into the structure. When a bridge is being renovated, we examine how a modification affects the rest of the system and whether fatigue, deformation or corrosion warrants further investigation.


For navigation locks and weirs, we assess lock gates, sluice gates, supports and drive systems. We use the specified water levels and operating conditions to determine the relevant loads. For pumping stations, we help integrate pumps and pipework with their supports and foundations. Vibration and loads at pump nozzles can govern the design. Assessing the machinery and supporting structure together helps us identify potential problems during design.
Water pressure, vessel contact and mooring forces place different demands on waterfront structures. Depending on the agreed scope, we assess port structures, fender systems and water-control barriers. For sheet pile walls and flood defences, we establish the design assumptions with the disciplines responsible for the adjoining works. When assessing existing components, we use available inspection data to account for deterioration and the cross-section that remains available to carry load.


Our work covers components of viaducts and tunnels as well as foundations for machinery, equipment and cranes. We identify the loads and determine how they transfer to adjacent structures. For underground infrastructure, we assess how sewers, rising mains, water mains and district heating pipes fit within the surrounding works. We coordinate ground data, pipeline routes and service crossings with the teams responsible for each discipline.
HIGTEC uses structural calculations and finite element analysis (FEA) to assess the strength, stability and fatigue performance of components and connections. For steel and concrete structures, we select a calculation method suited to the material, structural arrangement and applicable assessment criteria. For existing assets, we combine drawings with inspection findings, measured dimensions and actual service loads. This helps you determine whether the structure needs repair, strengthening or further investigation.


Your project team needs drawings it can use to plan construction, renovation and maintenance. Depending on the scope, we produce 3D models, general arrangement drawings, detail drawings and interface drawings. The supporting calculations document the loads and assumptions behind the design, so the teams responsible for construction and maintenance can see how key decisions were made.
Do you need to design, renovate or verify a bridge, lock, pumping station or other infrastructure asset? Share your technical question and the available drawings or inspection records with HIGTEC. We will discuss the assessment your project needs and identify any additional information required.